Volume 6 Preprint 56


Galvanic Corrosion of 27SiMn Coupled with Anthracite in a Mine Water

Zhang Zeng-Zhi, Xu Hai-Feng and Cao Peng

Keywords: 27SiMn; anthracite; electrochemical corrosion

Abstract:

Because you are not logged-in to the journal, it is now our policy to display a 'text-only' version of the preprint. This version is obtained by extracting the text from the PDF or HTML file, and it is not guaranteed that the text will be a true image of the text of the paper. The text-only version is intended to act as a reference for search engines when they index the site, and it is not designed to be read by humans!

If you wish to view the human-readable version of the preprint, then please Register (if you have not already done so) and Login. Registration is completely free.

Volume 6 Paper C132 GALVANIC CORROSION OF 27SiMn COUPLED WITH ANTHRACITE IN A MINE WATER ZHANG Zeng-zhi XU Hai-feng CAO Peng (China University of Mining and Technology , Beijing Division, Beijing 100083,China) Abstract. This paper investigates the galvanic corrosion of 27SiMn coupled with anthracite in a mine water. The results show that 27SiMn is anode, anthracite is cathode and anthracite accelerates the oxidation of cathode and quickens the corrosion of 27SiMn. Key words. 27SiMn; anthracite; electrochemical corrosion INTRODUCTION In the environment of coal mine, the electrical characteristics of anthracite accelerates the corrosion of structural materials. 27SiMn(0.24 ~ 0.32%C,1.10 ~ 1.40%Si,1.10~1.40%Mn) is one of the main structural materials used under pit in China. In the pit of anthracite, the severe corrosion of hydraulic prop which is imbedded in the coal is a primary factor that causes prop hydro-cylinder useless. In this paper the properties of galvanic corrosion of 27SiMn with anthracite are studied. It provides important foundation data for the corrosion prevention of structural materials used in coal mine. EXPERIMENTAL METHOD Fig.1 shows the sample used in galvanizing corrosion test. Anthracite (cathode) is cubic with one side exposed. 27SiMn acts as anode. The pH level of the mine water is 7.0~7.4. EXPERIMENTAL RESULTS AND DISCUSSION By chemical analysis, we got the following ion concentration(mg/L) in the mine water: 15~28 Cl-, 59~190 SO42-, 226~396 HCO3-, 18~36 K+ + Na+, 18~35 Mg2+, 65~137 Ca2+ . The content of C in absolutely dry anthracite matrix is more than 90%. Because there is a great difference between free corrosion potentials of 27SiMn and anthracite in mine water, the contact of 27SiMn and anthracite leads to galvanic corrosion and the corrosion rate of 27SiMn is accelerated. The variation of free corrosion potential as time goes on and the polarization test result of electrokinetic potential of 27SiMn in a mine water reveal that the free corrosion potential of 27SiMn is –720mV/SEC in steady state while the free corrosion potential of anthracite is nearly +155mV/SEC in the same condition. 27SiMn becomes the anode when it gets into anthracite because its free corrosion potential is remarkably lower than that of anthracite. Cathode-anode area ratio (CAAR) exerts a great influence on galvanic corrosion. Greater cathode-anode area ratio accelerates galvanic corrosion. It can be illustrated by the relation of corrosion potential and corrosion current versus time under different area ratio of 27SiMn and cathracite. According to the experimental results, when the areas of cathode and anode are of the same, the steady potential of galvanic couple is approximately –650mV/SCE. It is 180mV more than free corrosion potential of 27SiMn. The variation of galvanic current with time is as follows: When the areas of the two electrodes are of the same, the current density of galvanic couple decreases exponentially with time greatly. The current density is 50μA/cm2 in steady state (an hour later after the two contacting with each other). When CAAR=2, the galvanic current density decreases linearly with time. The falling rate is absolutely lower than that of the former condition. When CAAR=3, the variation of current density with time is more complicated. We can see, when CAAR=3, current density varies without obvious single regular. And an hour later the current density reaches up to about 480 2 μA/cm2.The result of the electrokinetic potential polarization test displays that the free corrosion current density of 27SiMn in mine water is 31.6μA/cm2 when it is not coupled with anthracite. The corrosion of 27SiMn in a mine water is greatly accelerated with the increasing of CAAR when coupled with anthracite Fig. 2 to Fig .5 show the experimental results of electrochemistry under a variety of conditions. CONCLUTIONS Mine water is neutral solution. During the corrosion of 27SiMn, oxygen is released at cathode. Once 27SiMn contacts with anthracite, anthracite becomes an indefinitely great cathode area which effectively weakens cathodic polarization, promotes oxygen releasing at cathode and accelerates the corrosion of 27 SiMn. 3 4 1. REFERENCES Cao Chunan. Corrosion electrochemistry. Journal of chemistry industry,1994.59 2. Song Shizhe. Study methods of corrosion electrochemistry. Journal of chemistry industry,1988.66 5